NoMachine is the only supported method of remote connection for Macs on campus. These instructions will show ou you how to remote into an office or research lab Mac device.
| Note |
|---|
| Info |
You will need to install NoMachine on both NoMachine must be installed on BOTH computers. You can download the client for your personal machine here. |
| Note |
|---|
The remote computer you are accessing must be connected to the TAMU network via Ethernet |
You will need to know the IP address of the Mac to connect to the remote computer |
| Table of Contents |
|---|
. The remote computer you are accessing must be connected to the TAMU network via Ethernet. |
Connecting from a Windows Device
Install the NoMachine client using the Self-Service Portal
Please note, it may take up to 20 minutes to install. You will receive a security prompt once the software is installed.
Connect to the TAMU network:
If you are on campus, connect to the Wi-Fi network “TAMU_WiFi” or “eduroam.”
If you are off campus, connect to your local Wi-Fi network, then open . Open the Cisco AnyConnect VPN application and log in using your NetIDand password.
Install NoMachine on your Windows device and start the application
Click the Add button
Enter a friendly computer name and the IP address of your machine, then click Connect
If you do not know the IP address, please contact engr-helpdesk@tamu.edu for assistance
If the IP address is valid, it will prompt you to put in your credentials. Enter the local username and password for the Mac device you are trying to access. If you would like NoMachine to remember your credentials, check the “Save Save this password in the connection file” file box.
If the connection is successful, you will be shown general tips for using the menu. It is recommended to read through the tips once, but you can check the box for each if you don’t want to see the tips every time you connect.
